Updated : Aug 13, 2020 in Uncategorized

LED Strip Lights Under Kitchen Cabinets

Under cabinet lighting is a relatively inexpensive and surprisingly effective method of enhancing the look and feel of your kitchen area. Not only is it aesthetically pleasing, but it also serves a practical purpose by creating more gentle on work tops which are or else left in shadow. To get the most effective results for minimal effort, really want to try using self-adhesive LED Strip Lights?

To install strip lights you will need to measure the duration of your cabinets and ensure there is an appropriate mains power supply close by. When taking measurements, always bear in mind that strip lighting can only be cut at second . 5, 5 or 10 cm intervals, so round up or down where necessary.
Should you liked this post and you wish to receive guidance concerning LED Panel kindly check out our own internet site.

LED Strips can be powered from a standard mains wall plug or they can be wired into a current lighting circuit. The question you need to consider is whether you want your strip lamps to come on at the same time as your primary kitchen lights or if you want to have the ability to control them independently.

As LED Strips have a self-adhesive backing you will not need to purchase any additional mounts or attachments, but if you are installing all of them near any sinks, kettles or other potential sources of condensation, it really is worth investing in at least an IP65 rated coating to prevent against short-circuits.

As a rule-of-thumb, cool white LED Strip Lights are the best single colour strips to use in this application as the lighting is clear and bright.

Don’t forget to discover the possibilities of a dimmer switch as this will allow you to vary the brightness of the strips. For dimmability you will need either a dimmable driver or a 12V dimmer switch which installs between the motorist and the strip lights.

In most kitchen areas you will find that the cabinets are not linked in one continuous run, but are usually instead separated by gaps. This can present a problem if you want to install BROUGHT Strips on all your cabinets, but only have one power point obtainable. This can be overcome by connecting your strips in series or parallel using 12V cable.

In the previous case you will simply bridge the particular gap between each cabinet with a length of cable, in the latter situation each strip is run to the power supply separately. If possible we all always recommend connecting in parallel as this minimizes the likelihood of voltage fall.

So to recap:

– Take Measurements,

– Make sure there is a power stage available,

– Choose an IP65 rated coating if necessary,

– Select a colour temperature to match the decor,

– Pay attention to the spacing of your cupboards and work out how you will link your strip lights back to your power point.

Of course it isn’t just the underside of your kitchen cabinets that can benefit from LED Strip Lights. They can also be installed along the top side facing towards the ceiling and along the kickboards.

Peter Jenny is an experienced author with a Masters Degree in Procedures Management. Peter has a wealth associated with experience in the lighting industry and is keen to share his knowledge about forthcoming products and new discussions around BROUGHT lighting. He is currently working being a Content Manager at Wholesale DIRECTED Lights, UK.

Leave a Reply

Your email address will not be published. Required fields are marked *